Spline¶
Sketches a smooth cubic spline through the points clicked, open or closed.
Sketch tab > Spline (on the split button with Line and Centerline), or press S.

Drawing a Spline¶
- Click Spline.
- Click the points the spline passes through, in order.
- End it: double-click, or press Enter or Esc. An open spline needs two points. To close it, click the first point again after three points or more. A closed spline is smooth at that point too.
Each point snaps and takes relations as a line's endpoints do (see Automatic Relations). The spline's points are ordinary sketch points: drag them, dimension them or relate them, and the curve follows.
End Handles¶
Select an open spline to show a handle at each end.
- Drag a handle to set the direction the spline leaves that end and how far it runs that way.
- Where a Tangent relation sets the end's direction, dragging the handle changes only how far it runs.
- Double-click a handle to free that end again.
Dimension on a spline dimensions its length.
Sketch Page¶
When a spline is selected, the Sketch page shows Selected Entities, Add Relations, Existing Relations, and under Options the For construction check box, Fix, Float and Delete. Select one of its points to set its X and Y under Parameters.