Skip to content

Exploded View

Moves components apart in steps along set directions to show how the assembly fits together.

Assembly tab > Exploded View, or right-click the assembly at the top of the design tree > Exploded View….

The Exploded View page with its step list, beside an exploded gearbox assembly.

Creating an Exploded View

  1. Click Exploded View. The first time, the assembly is exploded at once with Auto Explode.
  2. Delete the steps you don't want, or click Auto Explode to start again.
  3. To add a step, select a component, set the Direction and Distance, and click Add Step for the Selected Component.
  4. Drag the slider under Show to check the order of the steps.
  5. Click OK or press Enter.

An assembly has one exploded view, saved with it. It is the same in every configuration. Cancel puts the view back as it was before the page opened.

Explode Steps

The steps in order, each as its number, the components it moves and its distance, such as 2. Shaft<1>: 40 mm. Click the delete button on a step's row to remove it. A component in several steps moves by all of them, and a sub-assembly moves with what it holds.

Auto Explode
Replaces the steps with one step for each of the assembly's own components, moving it straight out from the middle of the assembly by half the assembly's diagonal, at least 10 mm. The first fixed component stays where it is. Suppressed components are left out.

Add Step

Direction
The direction along the assembly's axes: +X, -X, +Y, -Y, +Z or -Z. Default +Z.
Distance
How far the step moves the component, in the assembly's units. Default 50 mm (2 in).
Add Step for the Selected Component
Adds a step that moves the component selected in the design tree or the graphics area. A component inside a sub-assembly can be selected.

Show

Collapsed to exploded

A slider that plays the steps one after another, from the assembly collapsed (left) to fully exploded (right). It only previews; after OK the view is shown fully exploded.

The same assembly with the slider part way, the first steps done and the later ones not started.

Show exploded after closing
Keeps the assembly shown exploded after OK. Clear it to show the assembly collapsed. On when the page opens.

While the assembly is shown exploded, components cannot be dragged, and the status bar says so.

Explode / Collapse

Assembly tab > Explode / Collapse (on the split button with Hide / Show and Isolate), or the command palette.

Shows the assembly fully exploded, or collapsed if it is shown exploded. If the assembly has no exploded view yet, it opens Exploded View instead, which creates one with Auto Explode.

Opening Exploded View and clearing Show exploded after closing also collapses the assembly, and so does switching to another document and back.

See Also