Auxiliary View¶
Adds a view square on to a straight edge of a view, to show an inclined face at its true shape.
View Layout tab > Auxiliary View.
Adding an Auxiliary View¶
- Click Auxiliary View. The status bar says what to do next.
- Move the pointer over a view. The edge under it is highlighted.
- Select a straight edge, with the pointer on the side of the edge the new view looks from.
The view looks at the model square on to the edge, from the side the edge was selected on. It is placed a gap past the view on that side, selected, and the tool ends. Drag it where it goes: an auxiliary view is not kept in line with its parent.
An edge of a detail view cannot be used. Press Esc to end the tool without adding a view.
img/drawings/auxiliary-view.png
A front view of a part with an inclined face, its arrow and letter A, and VIEW A showing the face at its true shape.
What the Drawing Shows¶
- On the parent view
- An arrow square to the edge, past the view on the side the auxiliary view looks from, pointing the way it looks, with the view's letter at its tail.
- Under the auxiliary view
- Its label, VIEW A. Letters are given in order, A, B, C and so on, shared with section and detail views, skipping I, O, Q, S, X and Z.
An auxiliary view always has its parent's scale, and starts with its display style and tangent edges. Its letter, display style and rotation on the sheet are set on its page (see View Properties). A section view cannot be cut from an auxiliary view.