Shell¶
Hollows the part to a wall thickness, leaving the selected faces open.
Features tab > Shell.

Creating a Shell¶
- Select the faces to remove in the graphics area. You can also select them after the page opens.
- Click Shell.
- Set the Thickness. The preview updates as you type.
- Click OK or press Enter.
The wall is offset inward from the part's faces. Selecting a face already in the list removes it.
Parameters¶
- Thickness
- The wall thickness, in the part's units. Accepts an equation or a variable name.
- Faces
- The faces to remove; the shell is open there. At least one is needed. Select a row and press Del to remove it.
When a Shell Fails¶
If the shell cannot be built, the page shows the reason beside it.
Where the fillets just before the shell make faces the inward offset cannot take, such as a convex round smaller than the wall, the inside is made from the part as it was before those fillets, and the fillets are made again inside (their radii less the wall on convex edges, more on concave ones). The feature shows a warning naming any concave fillets left out inside, where the wall is then thicker.