Skip to content

Mirror Entities

Creates copies of sketch entities mirrored about a line, kept symmetric to the originals.

Sketch tab > Mirror Entities (on the split button with Offset Entities and Convert Entities).

The Mirror Entities page beside a half profile drawn against a vertical centerline, with its mirrored copy closing the profile.

Mirroring Entities

  1. Select the entities to mirror and the centerline to mirror about. You can also select them after the page opens.
  2. Click Mirror Entities.
  3. To change the line, click the Line box and select it. Once the line is set, selections go to Entities again.
  4. Click OK or press Enter.

When the page opens with a selection, a centerline in it becomes the Line. Without a centerline, the line selected last becomes the Line when more than one entity is selected. The rest go into Entities. With entities but no line, the page opens on the Line box.

The copies are selected when the page closes.

Entities to Mirror

Entities
The sketch entities to mirror: lines, arcs, circles and splines. References to model edges cannot be mirrored. Select an entity again, or press Del in the box, to remove it.

Mirror About

Line
The centerline or line to mirror about. Any line works, construction or not.

Relations Added

  • Each copied point gets a Symmetric relation to its original about the line, so the copies follow changes to the originals.
  • A mirrored circle gets an Equal relation to its original.
  • Points that lie on the line are shared, not copied, and kept on the line, so a half profile closes into one outline.
  • A copy is construction geometry when its original is.

See Also