Skip to content

Delete Face

Removes faces and extends the faces around them to close the gap: a hole or pocket filled flush, a boss removed, a fillet or chamfer back to a sharp edge. Works on any body, including imported STEP bodies that have no features to edit.

Features tab > Shell drop-down > Delete Face.

Deleting Faces

  1. Select the faces to delete in the graphics area. You can also select them after the page opens.
  2. Click Delete Face.
  3. Click OK or press Enter.

The faces around the deleted ones keep their surfaces and names, so features that refer to them still do.

  • Holes and pockets: select a wall. Both halves of a cylindrical wall are deleted, and a blind hole's floor goes with it. The face the hole was cut into fills across.
  • Bosses: select the side. The top goes with it, and the face the boss stood on fills across.
  • Fillets and chamfers: select the blend faces. The faces on each side are extended until they meet. Select a chain of fillets around an edge loop as a whole.
  • Corners: select the three fillets or chamfers on the edges at a corner and the patch between them. The three faces are extended to meet at a sharp corner again.

The faces around the gap must be able to close it. A fillet whose ends run into other fillets can be deleted only together with them. A part filleted on every edge, or a hole that breaks out through a side, cannot be deleted yet.

Faces to Delete

Faces
The faces to delete. Select a row and press Del to remove it.

See Also