Centerpoint Arc, 3 Point Arc and Tangent Arc¶
Sketches circular arcs from a center, through three points, or tangent to the end of a line or arc.
Sketch tab > Centerpoint Arc, 3 Point Arc or Tangent Arc (on one split button), or press A for Centerpoint Arc.

Each tool stays active for the next arc; press Esc to cancel the arc in progress, and again to return to the Select tool.
Centerpoint Arc¶
- Click Centerpoint Arc.
- Click the center.
- Click the start point. This sets the radius.
- Move the cursor around the center the way the arc should run, and click the end point.
The arc runs in the direction the cursor swept from the start point, so it can be drawn either way round and past half a circle. The end point is placed on the radius in the direction of the click.
The center and start point snap and take relations as a line's endpoints do (see Automatic Relations). The end point is shared with an existing sketch point, or made Coincident with the origin, when clicked on one; it takes no other relation.
3 Point Arc¶
- Click 3 Point Arc.
- Click the start point.
- Click the end point.
- Click a point the arc passes through. This sets its radius and which side it bulges to.
The start and end points snap and take relations as a line's endpoints do. The third point and the center take none.
Tangent Arc¶
- Click Tangent Arc.
- Click the endpoint of a line or arc.
- Click the end point of the arc.
The arc leaves the line or arc along its direction, and a Tangent relation holds it so. Its end point snaps and takes relations as a line's endpoints do. If the first click is not on the endpoint of a line or arc, the status bar shows "Tangent Arc must start at the endpoint of a line or arc." and nothing is drawn.
Sketch Page¶
When an arc is selected, the Sketch page shows Selected Entities, Add Relations, Existing Relations, and under Options the For construction check box, Fix, Float and Delete. Select its center or an endpoint to set its X and Y under Parameters. Dimension on an arc dimensions its radius.