Break and Crop¶
Three ways to show less of a view: Break leaves out a stretch of a long part, Broken-out Section cuts away material to show what is inside, and Crop View shows only part of the view.
View Layout tab > Break and Crop > Break, Broken-out Section or Crop View.
None of them can be used on a detail view. Each tool ends after one use; press Esc to end it without changing the view.
Break¶
Leaves out the stretch of a view between two points and brings the rest together, with break lines at the gap.
- Click Break.
- Click on a view where the gap starts.
- Click where it ends.
The gap runs across the view when the two points are farther apart across it than up it, otherwise up the view. The two points must be at least 3 mm apart on the sheet. A view has one break: breaking it again replaces the break.
To restore the view, right-click it > Remove Break, or select its break lines and press Del.
img/drawings/break-view.png
A long shaft's view with a break, its middle left out and break lines at the gap.
Broken-out Section¶
Cuts away the material inside a box on a view, from the front of the model to a set depth, and hatches what it opens.
- Click Broken-out Section.
- Click one corner of the area to cut away on a view.
- Move the pointer. The box follows it. Click the opposite corner.
The corners snap to hole centers and edge ends. The cut goes half the model's depth along the view to start with. The view is selected and its page opens, with a Broken-out Section group:
- Depth
- How deep the material inside the box is removed, measured from the front of the model, in the drawing's units.
- Remove Broken-out Section
- Takes the cut away.
A view has one broken-out section: adding another replaces it.
img/drawings/broken-out-section.png
A view with a broken-out section showing a bore inside the part, hatched, and the Broken-out Section group on its page.
Crop View¶
Shows only the geometry of a view inside a box drawn on it.
- Click Crop View.
- Click one corner of the area to keep on a view.
- Move the pointer. The box follows it. Click the opposite corner.
The corners snap to hole centers and edge ends. What is kept stays where it was on the sheet. The view is selected and its page opens, with a Crop group:
- Remove Crop
- Shows the whole view again, the part kept staying where it is.
For both box tools, the box must be at least 2 mm wide and high on the sheet.
img/drawings/crop-view.png
A cropped view showing one end of a part, and the Crop group on its page.