Skip to content

Corner Rectangle and Center Rectangle

Sketches a rectangle of four lines, held square by Horizontal and Vertical relations.

Sketch tab > Corner Rectangle or Center Rectangle (on one split button), or press R for Corner Rectangle. In the graphics area, right-click > Rectangle also starts it.

A center rectangle on the origin, showing its two construction diagonals and the Horizontal and Vertical marks.

Drawing a Corner Rectangle

  1. Click Corner Rectangle.
  2. Click the first corner.
  3. Click the opposite corner.

The tool stays active for the next rectangle; press Esc to return to the Select tool.

Drawing a Center Rectangle

  1. Click Center Rectangle.
  2. Click the center.
  3. Click a corner.

Relations Added

Rectangle Relations
Corner Top and bottom Horizontal, sides Vertical
Center As Corner, plus two construction diagonals with the center at the Midpoint of each

The two points clicked (the corners, or the center and the corner) snap and take relations as a line's endpoints do (see Automatic Relations). Click the center of a center rectangle on the origin to center it there.

Sketch Page

The rectangle is four lines; select them one at a time or together. The Sketch page shows Selected Entities, Add Relations, Existing Relations, and under Options the For construction check box, Fix, Float and Delete. Select a corner to set its X and Y under Parameters.

See Also