Skip to content

Point

Sketches points, for hole positions and as references for dimensions and relations.

Sketch tab > Point, or press P.

A selected sketch point with the Sketch page showing its X and Y under Parameters.

Placing Points

  1. Click Point.
  2. Click where each point goes.

The tool stays active; press Esc to return to the Select tool. Each point snaps and takes relations as a line's endpoints do (see Automatic Relations), so a point clicked on a line's midpoint or a model edge stays there.

The position sketch the Hole command opens is a points-only sketch: its page is titled Hole Positions, and only Point, Dimension and the Select tool work in it.

Sketch Page

When one point is selected, the Sketch page shows:

Selected Entities
The point, by name (Point1).
Add Relations, Existing Relations
As for any sketch entity. See Relations.
Options
For construction, Fix, Float and Delete.
Parameters
X and Y: the point's position in the sketch, in the part's units. A value typed moves the point as a drag would, as far as its relations and dimensions allow.

See Also