Skip to content

Mirror

Mirrors features about a plane or planar face.

Features tab > Mirror, or Insert > Pattern/Mirror > Mirror.

The Mirror page beside a part with a feature mirrored about a plane.

Creating a Mirror

  1. Select the features to mirror and, optionally, the mirror plane or planar face. You can also select them after the page opens.
  2. Click Mirror.
  3. Check the Plane. With no plane or planar face selected, it starts on the Right Plane.
  4. Click OK or press Enter.

Extrusions, revolves, sweeps, helical sweeps, lofts, threads, holes, fillets, chamfers, patterns and mirrors can be mirrored. The mirrored copy is added to or removed from the body as its seed is; the seed stays.

Mirror Face/Plane

Plane
The mirror plane: a plane or a planar face.

Features to Pattern

Features
The features to mirror. Select them in the design tree or the graphics area; selecting a face selects the feature that created it. Sketches are not added.

When a Mirror Fails

The page shows the reason when the mirror cannot be built. A copy that cannot be applied to the body is left out, and the feature shows a warning. A suppressed seed is left out with a warning; with all seeds suppressed, the mirror is suppressed too.

See Also