Convert to Sheet Metal¶
Converts a solid body of one thickness, modeled or imported, to sheet metal: its walls become panels and the round edges between them become bends.
Sheet Metal tab > Convert to Sheet Metal, or Insert > Sheet Metal > Convert to Sheet Metal….
img/sheet-metal/convert-to-sheet-metal-page.png
The Convert to Sheet Metal page beside an imported enclosure.
Converting a Body¶
- Select the body in the graphics area, or a planar face of it to make that face the fixed face. A part with one solid body needs no selection.
- Click Convert to Sheet Metal. The page opens with the gauge whose thickness is nearest the body's.
- Check Material and gauge, and the Fixed face if another face should stay in place.
- Click OK or press Enter.
The converted body is replaced by the sheet. Later sheet metal features (Edge Flange, Hem, Sheet Cut) work on it as on a sheet made with Base Flange.
Parameters¶
Body¶
- Body
- The solid body to convert.
- Fixed face
- The planar face that stays in place. It is the sheet's top side. Blank: the largest planar face.
Sheet¶
- Material and gauge
- The material and gauge from the shop profile in use. The gauge's tooling gives the bend allowances.
- Thickness
- Blank: the gauge's thickness, which the body must match within the gauge's tolerance. An entered thickness replaces the gauge's. The page fills it in when no gauge in the profile is as thick as the body.
- Grain direction
- The grain's angle in the flat, in degrees. Optional. Bends are checked against it where the material is grain sensitive.
What Is Converted¶
- Bends: cylindrical faces between walls keep their own radii and angles. The shop profile gives their allowances.
- Sharp edges between walls get the profile's inside radius.
- Closed corners are ripped.
- Double layers at an edge become closed or open hems. The shop profile must allow that hem type in the gauge.
- Bends folded back flat (180°) become open hems at their own radius. The return keeps its holes and cutouts. The shop profile gives the hem allowance.
The body's thickness is measured behind the fixed face, where most of the sheet is, so a recess behind a stamped form does not change it.
Stamped Forms¶
A stamped form inside a wall, such as a raised pad, a plaque or embossed letters, is found and taken off the sheet: the flat pattern is cut without it. On OK, Convert creates a Formed Feature for each form in a Forms folder right after it in the design tree, which puts the form back on the sheet.
While the page is open, the preview shows the forms flat. Editing Convert and clicking OK again writes the folder anew: each Formed Feature keeps its name, suppression and mark, a form no longer found loses its feature, and a new one gets one.
Warnings¶
- N stamped forms are left flat. Edit this feature and click OK to add their Formed Features.
- The part was converted before its forms had Formed Features. Edit Convert and click OK.
- The sheet's volume differs from the body's.
- Part of the body is not a uniform sheet joined by bends, such as a thicker boss or a wall no bend reaches. It is left out of the sheet.