Skip to content

Interference Detection

Finds parts of the assembly whose volumes overlap and highlights each pair in red.

Assembly tab > Interference Detection (on the split button with Bill of Materials), or right-click the assembly at the top of the design tree > Interference Detection.

The Interference Detection window with three interferences listed and the selected pair highlighted red in the assembly.

Checking for Interference

  1. Open an assembly.
  2. Click Interference Detection.
  3. Set Check interference within sub-assemblies.
  4. Click Calculate. The note below the list shows progress.
  5. Select an interference in the list to highlight its two parts.
  6. Click Close or press Esc.

The window does not block the app. After changing the assembly, click Calculate again.

What Is Checked

  • Every part at every level, hidden parts included. Suppressed parts are left out.
  • Only parts whose bounding boxes overlap are intersected, so the check is quick when few parts are close.
  • Parts that only touch, face to face, are not reported.
  • The bodies of one part are not checked against each other.
  • A part shown only from a copy, with no solid to check, is skipped and listed in the note.
Check interference within sub-assemblies
On by default. Off, parts of the same top-level sub-assembly are not checked against each other, only against the rest of the assembly.

Results

Each interference is one row: the two parts and the volume they share, in the assembly's units. A part in a sub-assembly is named with its path, such as Gearbox<1>/Shaft<1>.

Bracket<1>  ↔  Gearbox<1>/Shaft<1>:  12.566 mm³

The largest interference is listed first. The note below the list gives the count, or No interference among the number of parts checked, followed by up to six parts or pairs that could not be checked. If the check itself fails, the note reads Could not check interference: and the reason.

Select a row to show that pair in red in the graphics area; the status bar repeats the two names and the volume. Closing the window removes the highlight.

Close-up of two interfering parts highlighted in red, with the status bar giving their overlap volume.

See Also