Thread¶
Adds a modeled or cosmetic thread to a cylindrical face: external on a shaft, internal in a hole.
Features tab > Hole drop-down > Thread.

Creating a Thread¶
- Select a cylindrical face near the end where the thread starts. You can also select it after the page opens.
- Click Thread.
- Set the Size and the end condition. The preview updates as you change them.
- Click OK or press Enter.
The thread starts at the face's free end, a shaft's tip or a hole's opening, and runs toward the shoulder or the hole's bottom. Where the faces at the ends don't tell which end is free, it starts at the end nearest the point clicked on the face.
Face¶
- Face
- The cylindrical face of a shaft or hole.
Specification¶
- Size
-
The thread size:
Option Size Auto (ISO metric, fits the face) The ISO metric coarse size whose major diameter (shaft) or minor diameter (hole) is nearest the face's A library size A size from the thread tables the libraries offer, such as ISO metric coarse and fine, UNC and UNF. Metric sizes show their pitch, as M10 × 1.5Custom pitch The Pitch (custom), with the face as the major diameter (shaft) or minor diameter (hole) On a shaft the thread follows the shaft's diameter. Where the size differs from it by more than 15%, the feature shows a warning. A size the libraries no longer offer stays on the thread, shown as not offered.
- Pitch (custom)
- The pitch, in the part's units. Used only with Custom pitch.
- End
-
Where the thread ends, chosen from a row of buttons:
Option Thread Blind For the Length (blind) from the start end Up To Next Up to the face's far end, short of the head or a shoulder Through All The whole length of the face (nuts, through holes) - Length (blind)
- The thread length for Blind. Empty, the thread runs up to the face's far end.
Options¶
- Clearance
- Extra flank and root clearance, for 3D-printed threads; typically 0.1–0.3 mm.
0by default. Where the crest would become too narrow, it is truncated: the shaft is turned down, or the hole bored out, over the thread. - Lead-in chamfer
- A 45° chamfer at the start end (a countersink in a hole), and at the far end of a Through All thread. On by default.
- Cosmetic thread
-
Shows the thread as a helix on the face instead of modeling the groove. The lead-in chamfer and relief groove are still modeled, and exports always model the thread. View > Threads overrides the display of all threads (As Set in Each Thread, All Modeled, All Cosmetic (lightweight)).

- Thread end
-
How a thread that stops in the material ends, chosen from a row of buttons. Not used by Through All.
Option End Plain The thread stops square Relief groove An undercut two pitches wide at the end, for tool clearance at a shoulder Tangent run-out (shafts) The thread groove exits the shaft along the helix tangent Tangent run-out applies to shafts only; in a hole the thread ends plainly, with a warning.

- Left hand
- A left-hand thread.
- Start at the other end
- Starts the thread at the face's other end.