Balloons¶
A balloon labels a component in an assembly view with its item number from the Bill of Materials. Balloons and the BOM table are numbered the same way, so they always agree.
Annotation tab > Balloon or Auto Balloon (on the Balloon split button).
A new drawing of an assembly comes with a BOM table and balloons on its isometric view.
img/drawings/balloons-view.png
An isometric assembly view with numbered balloons around it, their leaders ending in dots on the components, and the BOM table beside it.
Adding a Balloon¶
- Click Balloon.
- Select an edge of a component in an assembly view.
- Click where the balloon goes.
- Add the next balloon, or press Esc to end.
The balloon is a circle with the item number in it, and a leader ending in a dot on the edge.
Auto Balloon¶
- Select a view of an assembly. Without a selection, Auto Balloon works on the sheet's first assembly view.
- Click Auto Balloon.
Each item the view shows gets a balloon on its longest visible edge, unless it has one in that view already. The balloons are set out around the view, clear of it, of each other and of the sheet's other views. Auto Balloon is one undo step. When every item has a balloon, the status bar says so and nothing is added.
Item Numbers¶
A balloon's number is its component's item in the assembly's top-level Bill of Materials: one item for each part or sub-assembly, instances of the same one sharing it, numbered in the order of the assembly. A component inside a sub-assembly shows the sub-assembly's item. The numbers follow the assembly as it changes. See Bill of Materials.
Changing a Balloon¶
Select the balloon. The Balloon page opens in the property panel.
- Height
- Under Text Format: the height of the number on paper. Leave it empty for the height in the drafting standard. See Drafting Standard.
- Layer
- Under Text Format, once the drawing has layers. See Layers.
Drag the balloon to move it. Drag the dot at the end of its leader onto another edge to point it at another component. To delete a balloon, select it and press Del.
When the edge a balloon points at is gone from the model, its number is shown in red where it was, and it is listed in the design tree marked (Dangling). Delete it, or add it again.