Skip to content

Circular Pattern

Copies features around an axis.

Features tab > Circular Pattern, or Insert > Pattern/Mirror > Circular Pattern.

The Circular Pattern page beside a flange with a bolt circle of holes.

Creating a Circular Pattern

  1. Select the features to pattern in the design tree or the graphics area. You can also select them after the page opens.
  2. Click Circular Pattern.
  3. Select the Axis, or click X axis, Y axis or Z axis.
  4. Set the Angle and Instances. The preview updates as you type.
  5. Click OK or press Enter.

Extrusions, revolves, sweeps, helical sweeps, lofts, threads, holes, fillets, chamfers, patterns and mirrors can be patterned.

Parameters

Axis
A cylindrical face or circular edge (its axis), a linear edge, or a reference axis. Right-click a cylindrical face or circular edge > Select Axis also selects its axis. The X, Y and Z axis buttons use an axis through the origin; the one in use shows pressed. Pointing at a button shows its axis in the graphics area. The default is the Z axis.
Reverse direction
Patterns the other way around the axis.
Angle
In degrees. With Equal spacing on, the total angle the instances span; with it off, the angle between neighboring instances. Default 360°.
Instances
The number of instances, the seed included: 2 to 2000. Default 4.
Equal spacing

Spreads the instances evenly over the Angle. On by default.

Angle Instances placed
360° Evenly around the full turn, 360° / Instances apart
Less than 360° The seed at one end and the last instance at the other

With Equal spacing on, the angle must be more than 0° and at most 360°.

Four instances over 180° with Equal spacing on and with it off.

Instances to Skip

Instances

Instances to leave out, as numbers and ranges such as 2, 5, 7-9. The seed is instance 1; numbering runs around the axis in the pattern direction. Numbered markers show the instances in the graphics area; click one to add it to the list or remove it.

A bolt circle with its numbered instance markers, one instance skipped.

Features to Pattern

Features
The seed features. Select them in the design tree or the graphics area; selecting a face selects the feature that created it. Sketches are not added.

When a Circular Pattern Fails

The page shows the reason when the pattern cannot be built. An instance whose copy cannot be applied to the body is left out, and the feature shows a warning. A suppressed seed is left out with a warning; with all seeds suppressed, the pattern is suppressed too.

See Also