Skip to content

Mate Reference

Names a face of the part by the role it plays when the part is placed in an assembly, such as the shank or the seat of a screw. Library parts carry these, and Insert Fastener and Insert Standard Part mate parts by them.

Insert > Reference Geometry > Mate Reference.

Creating a Mate Reference

  1. Select a planar or cylindrical face, or a reference plane. You can also select it after the page opens.
  2. Click Mate Reference.
  3. Type the Role.
  4. Click OK or press Enter.

The reference is listed in the design tree. It fails, and says so, if its face is no longer there or a reference before it already has the role.

Seat on a plane

A library part's seat can be a reference plane where no face of the part is: a fitting that sits down in a spot face seats on a plane where the surface it is put on is, so it goes down into the spot face with it.

Up

On the planar face or plane a library part sits on (its seat), Up direction says which way along the face is up: a latch's handle, for example. Dropped on a face, the part comes in with that direction up as the face is seen. Select a linear edge, face, plane or axis, or click X, Y or Z; Reverse turns it the other way. Without one, up is the part's +Y.

While a library part is open, its seat is tinted, with an arrow into the face it goes on and a green arrow showing up. The reference fails if the direction is square to the face.

Roles

Role Face Used by
shank A screw's cylindrical shank (its thread) Insert Fastener, Insert Standard Part
seat The planar face under a screw's head (a flat head's top) Insert Fastener, Insert Standard Part
shoulder A shoulder screw's shoulder Insert Standard Part
shoulder-end The planar face at the end of the shoulder Insert Standard Part
bore A nut's or washer's hole Insert Fastener
bearing The planar face of a nut or washer that bears on the part Insert Fastener
top A washer's other planar face Insert Fastener

A library family's placement rules name the roles they use, so a part modeled for a family needs those references.

See Also