Skip to content

Area Hatch

Hatches or fills model faces in views, or closed areas of sketches on the sheet.

Annotation tab > Area Hatch.

img/drawings/area-hatch-page.png

The Area Hatch page beside a front view with one face hatched with Lines (ANSI31) and a sketched area filled solid.

Hatching an Area

  1. Click Area Hatch. The sheet must have a view or a sketch.
  2. Set the Pattern, and for lines the Angle and Spacing.
  3. Click a face in a view, or inside a closed area of a sketch. The face or area under the pointer is outlined. It is hatched with the page's pattern.
  4. Click the next area, or press Esc or click OK to end.

A sketch's closed area is found before the views under it. In a view inside another's box, the smaller view is used.

Faces cannot be hatched in section, detail and broken views. In a cropped view, only the part inside the crop can be clicked.

A hatched face follows the model: it is hatched wherever the view shows it after the model changes. A hatched sketch area follows the sketch as it is edited.

Pattern

Pattern
Option Hatch
Lines (ANSI31) Parallel lines
Crossed lines (ANSI37) Two sets of lines at right angles
Solid fill The area filled solid
Angle (°)
The angle of the hatch lines on the sheet, counterclockwise from horizontal. Not shown for Solid fill.
Spacing
The distance between the hatch lines on paper. Not shown for Solid fill.

New hatches get the pattern used last.

Changing or Removing a Hatch

Click a hatched area on the sheet, or right-click it > Edit Hatch. Area Hatch opens with that hatch selected and its pattern on the page. With Area Hatch already on, click the hatched area.

Changes to Pattern, Angle and Spacing apply to the selected hatch at once, each one undo step. Click Remove Hatch to remove it.

To delete a hatch without opening the page, right-click it > Delete Hatch.

See Also