Skip to content

Straight Slot

Sketches a straight slot: two lines and two end arcs around a construction centerline.

Sketch tab > Straight Slot (on the split button with Polygon).

A straight slot being drawn, its two centers placed and the cursor setting the width.

Drawing a Straight Slot

  1. Click Straight Slot.
  2. Click the center of the first end.
  3. Click the center of the second end.
  4. Click a point to set the width. Its distance from the centerline is the end radius, half the slot's width.

The tool stays active for the next slot; press Esc to cancel the slot in progress, and again to return to the Select tool.

Relations Added

  • A construction centerline between the two end centers, which are the arcs' centers.
  • Tangent between each side line and each end arc.
  • The sides Parallel to the centerline.
  • The centerline Horizontal or Vertical, when the second center is placed level or plumb with the first.

Together these keep both end radii equal, so one radius dimension sizes the slot. The two centers snap and take relations as a line's endpoints do (see Automatic Relations); the width click takes none.

Sketch Page

The slot is its lines, arcs and centerline; select them one at a time or together. The Sketch page shows Selected Entities, Add Relations, Existing Relations, and under Options the For construction check box, Fix, Float and Delete. Select an end center to set its X and Y under Parameters.

See Also