Skip to content

Chamfer

Bevels the selected edges or faces.

Features tab > Chamfer (on the split button with Fillet), or right-click an edge > Chamfer.

The Chamfer page beside a part with chamfered edges, Options closed.

Creating a Chamfer

  1. Select edges or faces in the graphics area. You can also select them after the page opens.
  2. Click Chamfer.
  3. Select the Type and set the Distance, and the Distance 2 or Angle it needs. Distance has the focus when the page opens and gets it back, with its text selected, after each selection in the graphics area.
  4. Click OK or press Enter.

A selected face adds all of its edges. Selecting an item already in the list removes it.

Items To Chamfer

Edges
The edges, or faces whose edges, to chamfer. Select a row and press Del to remove it.

Chamfer Parameters

Type

How the chamfer is sized. Each button's tooltip names it.

Option Size
Distance The same distance on both faces
Angle-Distance A distance on one face, and the chamfer face at an angle to it
Distance-Distance A distance on each face

Distance is the default.

One edge chamfered as Distance, Angle-Distance and Distance-Distance, with the distances and angle dimensioned.

Distance
The distance along the edge's face, in the part's units: on both faces for Distance, on the reference face for the other types. Accepts an equation or a variable name. 1 mm by default (0.03 in in inch parts).
Distance 2
The distance along the other face. Shown for Distance-Distance only.
Angle
The angle of the chamfer face to the reference face, in degrees, between 0 and 180. 45° by default. Shown for Angle-Distance only.
Flip direction (measure on the other face)
Takes the edge's other face as the reference face, the one Distance and Angle are measured on. Shown for Angle-Distance and Distance-Distance.

Options

A folding section: click its title to open or close it. It is closed when the page opens unless one of its options differs from its default.

Tangent propagation
Also chamfers edges tangent-connected to the selected ones. On by default.
Overflow: trim at neighboring faces
Where the chamfer runs into neighboring geometry, it is trimmed by that geometry instead of failing. On by default.
Flat corners where three chamfers meet

Where three chamfered edges meet at a corner, cuts off the point they leave with a flat triangle through the corners of the faces between them. Off by default.

A box corner where three chamfers meet, with Flat corners where three chamfers meet off and on.

When a Chamfer Fails

If the chamfer cannot be built, the page shows the reason. Common fixes:

  • With Angle-Distance, reduce the Angle, or turn on Flip direction, where the chamfer would not reach the other face.
  • Turn on Overflow (under Options) where the chamfer runs into a neighboring face.

See Also