Skip to content

Motor

Turns a component about the axis of one of its cylindrical or conical faces at a set speed, so its mates drive the rest of the mechanism.

Assembly tab > Motor (on the split button with Mate).

The motor moves components through their mates: a gear turns its mating gear, a crank drives its linkage. The assembly needs mates before a motor can run. The motor is not saved with the assembly.

The Motor page with a crank's cylindrical face selected and the motor paused, the Turned readout showing about 270°.

Running a Motor

  1. Click Motor.
  2. Select a cylindrical or conical face of a floating component. The component rotates about the face's axis.
  3. Set the Speed.
  4. Click Play. Click Pause to stop where it is, or Reset to stop and return the components to where they started.
  5. Click OK to keep the components where the motor left them, or Cancel to put them back.

OK makes one undo point for the whole run. The Motor page cannot open while the Mate page is open.

A crank-slider mechanism partway through a turn under the motor, the crank's face highlighted as the motor axis.

Component/Direction

The selected face, shown as the component's name and face axis, or No face selected. Selecting another face stops the motor and uses that one. A fixed component, or a face that is not cylindrical or conical, is not accepted.

If the component is part of a rigid sub-assembly, the whole sub-assembly turns (see Sub-assemblies).

Reverse direction
Turns the component the other way.

Motion

Speed
In RPM. Accepts an arithmetic expression, such as 120/4.
Play, Pause
Starts and stops the motor.
Reset
Stops the motor and returns all the components to where they were when the page opened.
Turned
How far the component has turned since the page opened or was reset, in degrees.

When the Motor Stops

If the mates do not let the component turn any further, because it is held another way or the mechanism locks up, the motor stops one step back and the status bar names the mates that block it. Check those mates in the design tree (see Mate).

See Also