Skip to content

Sketch Fillet

Rounds the corner where two lines or arcs meet with a tangent arc, keeping the original entities as construction geometry.

Sketch tab > Sketch Fillet.

A rectangle with two corners filleted, the original lines shown dashed as construction to the sharp corners, and the radius dimension on one arc.

Filleting a Corner

  1. Set the Radius in the Sketch Fillet section of the sketch's page.
  2. Select a corner point where two lines or arcs end, or select the two entities one after the other.
  3. Repeat for other corners. Press Esc to return to Select.

Corners already selected when you click Sketch Fillet, as points or as pairs of entities that share an end, are filleted at once with the current radius, as one undo step (Ctrl+Z).

Sketch Fillet

The section appears on the sketch's page while the tool is active and nothing is selected.

Radius
The fillet radius, in the part's units. It applies to the corners filleted after it is set; each fillet gets its own radius dimension, which you edit like any other. The default is 5 mm (0.125 in in an inch part).

What a Fillet Creates

  • A tangent arc between the two entities, with a radius dimension.
  • A trimmed copy of each entity, running from its far end to the arc's tangent point. These carry the profile.
  • The original entities stay, ending at the corner, as construction geometry. Dimensions to the sharp corner keep working, and the tangent points stay on the originals.

A second fillet at the other end of a trimmed entity trims the same copy, so all four corners of a rectangle can be filleted in turn.

Delete the fillet arc to restore the corner: the trimmed copies go and the originals are solid again. Deleting another piece of a fillet leaves the rest as plain geometry.

When a Fillet Fails

The status bar gives the reason. Common causes:

  • The corner has more or fewer than two solid lines or arcs ending at it. Construction geometry and references to model edges there do not count.
  • The radius does not fit: the lines are too short for it, or no arc of that radius touches both arcs next to the corner.
  • The two lines are in line, so there is no corner.

See Also