Skip to content

Section View

Cuts a view along a cutting-plane line placed on it and adds the section view next to it, the cut faces hatched.

View Layout tab > Section View.

img/drawings/section-view-page.png

The Section View page beside a front view, the cutting-plane line previewed across it at a hole's center.

Adding a Section View

  1. Click Section View. The Section View page opens.
  2. Under Section, choose how the section is cut. The page keeps the choices for the next section.
  3. Move the pointer over a view. The cutting-plane line follows it, snapping to hole centers and edge ends.
  4. Click where the line goes.

The section is placed a gap past the view on the side chosen, and labeled with the next letter. It is selected and its own page opens, to go on editing it (see Editing a Section View). Drag it where it goes: a section cut up or across its parent moves only along its line, toward or away from the parent.

Only a front, back, top, bottom, right or left view, or a view projected square on to one, can be sectioned, not an isometric, auxiliary or detail view. Press Esc or click Cancel to end without adding a section.

Section

Cut

Where the section goes, and so which way the cutting-plane line runs:

Option Cutting-plane line Section
Section to the right Vertical To the right of the view
Section to the left Vertical To the left of the view
Section above Horizontal Above the view
Section below Horizontal Below the view
Angled section At the Angle set Off the view, square on to the line

A section is seen from the side it is placed on, whatever the sheet's projection angle: the material on that side of the line is cut away.

Angle (°)
With Angled section: the angle of the cutting-plane line on the view, counterclockwise from horizontal. 45 to start with.
Flip direction
With Angled section: the section is seen from the other side of the line.
Section depth
Shows only the material within a set depth behind the cutting-plane line. Material beyond it is not drawn.
Depth
With Section depth selected: how deep the slice shown is, in the drawing's units.

What the Drawing Shows

On the parent view
The cutting-plane line, a chain line drawn thick at its ends and past the view, with arrows pointing the way the section is seen and its letter at each end. Clicking the line selects the section view.
The section view
The model cut along the line, what lies toward the viewer removed and the cut faces hatched. It is drawn with hidden lines removed to start with, and cannot be shaded.
Under the section view
Its label, SECTION A-A. Letters are given in order, A, B, C and so on, shared with detail and auxiliary views, skipping I, O, Q, S, X and Z.

Editing a Section View

Select the section view, or its cutting-plane line on the parent, to open its page. The page has the view's name as its title, and starts with a Section group:

Cut, Angle (°), Flip direction, Section depth, Depth
As when adding it. Changing Cut places the section again on the new side.
Aligned with the cutting-plane line
For an angled section: turns the section on the sheet to line up with its cutting-plane line, instead of upright.
Full Length
Shown once the cutting-plane line has been shortened: restores it to run across the whole view.

The rest of the page is the view's own: Label, Display Style, Scale, Marks and the other groups, as described in View Properties. A section takes its parent's scale unless it has one of its own.

Showing Only Part of the Section

With the section selected, its cutting-plane line has a grip at each end on the parent view. Drag an end inward: only the material between the line's ends is shown in the section, and the line is drawn that long. The ends snap to the model. Full Length on the page restores the whole line.

img/drawings/section-view-partial.png

A section whose cutting-plane line has been shortened on the parent, showing only the material between its ends.

See Also