Skip to content

Sketch Axes

Turns the sketch's X and Y axes in its plane to follow a straight edge or a planar face of the model. The geometry stays where it is in the model; Horizontal and Vertical relations, and horizontal and vertical dimensions, then hold along the new axes.

Sketch tab > Sketch Axes, Sketch Axes… in the Sketch Axes section of the sketch's property panel, or Sketch Axes in the command palette. A sketch must be open. A Hole position sketch takes its axes from the hole and has no Sketch Axes.

The Sketch Axes page with a straight model edge in its Direction box, the sketch's X axis turned along that edge.

Aligning the Axes

  1. Open the sketch.
  2. Click Sketch Axes. An edge or face already selected goes into the Direction box.
  3. Select a straight edge or a planar face in the graphics area:
    • A straight edge: the X axis runs along it, the way nearest the X axis as it was.
    • A planar face: the Y axis runs along its normal, so the face is at the top.
  4. Click OK or press Enter.

The view turns with the axes, so the sketch is seen with its X axis to the right. An edge or face normal to the sketch plane cannot set the axes.

Selecting another edge or face replaces the one in the box. Selecting the one in the box again takes it out, and the sketch goes back to its plane's axes.

Align To

Direction
The straight edge or planar face the axes follow.
Reverse Direction
Turns the axes half a turn: X and Y point the other way.
Use Plane Axes
Clears the Direction box. The sketch uses its plane's own axes again.

Cancel or Esc puts the axes back as they were when the page opened. Each change on the page is also a step for Ctrl+Z in the sketch.

Aligning When Starting a Sketch

Select a plane or planar face, then Ctrl + select a straight edge, an axis, a planar face or a plane, and click Sketch. The sketch starts on the first selection with its axes aligned to the second, as on the Sketch Axes page.

How the Axes Are Kept

The sketch keeps the edge or face its axes follow. When the model changes, the axes follow it, and the sketch with them. The Sketch Axes section of the sketch's property panel shows whether the sketch uses its plane's axes or is aligned to the model.

See Also