Skip to content

Insert Components

Inserts parts and sub-assemblies into the assembly, linked to their files or embedded in it.

Assembly tab > Insert Components, or right-drag down in the graphics area. A new assembly opens it at once.

The Insert Component page listing two open parts and an open assembly, with Browse… below the list.

Inserting a Component

  1. Click Insert Components.
  2. Select a part or assembly in the list, or click Browse… and select one or more files.
  3. Set the Options and, for an assembly, Solve as.
  4. Click OK or press Enter. Double-clicking a row in the list inserts it at once, and files selected with Browse… are inserted as soon as the file dialog closes.

The first component in an assembly is fixed at the origin. Each component inserted after it goes beside the assembly, along +X, floating, and is selected. Drag it near its place, then mate it. See Mate.

Parts can also be dragged in: drag a saved part's row from the Open Parts list, or .sprt and .sasm files from the file explorer, into the graphics area. Each is inserted, linked, where it is dropped. See Assemblies.

Part/Assembly to Insert

The list
The parts open in other tabs, and the assemblies open in other tabs (marked with the assembly icon). Only saved documents are listed; save a new part before inserting it. A part with unsaved changes is inserted as it was last saved. With none open, the page says No saved part or assembly is open.
Browse…
Opens a file dialog for .sprt parts and .sasm assemblies. Several files can be selected at once.

Options

Embed parts in the assembly

Stores a copy of the part in the assembly file instead of linking to the part's file. Off by default.

Setting The component
Off (linked) Uses the part file. Saving the part updates the assembly
On (embedded) Uses the assembly's copy. Edit it with Open Part; Save writes it back into the assembly

Assemblies are always linked, whatever this is set to.

A linked part is found by its identity, so it is found again after its file moves. A part without an identity yet is saved once when it is inserted, and the design tree notes it.

Sub-assemblies

Solve as

How an inserted assembly behaves:

Option Behavior
Rigid Moves as one body, as its file has it
Flexible Its own mates are solved in this assembly, so its parts can move

Change it later with Make Flexible or Make Rigid on the component's menu. See Sub-assemblies.

An assembly cannot be inserted into itself.

See Also