Skip to content

Draft

Tapers faces by an angle to a pull direction, about a neutral plane, for mold release.

Features tab > Shell drop-down > Draft.

The Draft page beside a part with drafted side faces.

Creating a Draft

  1. Click Draft.
  2. Select the neutral plane or planar face. The next selections go to Faces.
  3. Select the faces to draft.
  4. Set the Angle. The preview updates as you type.
  5. Click OK or press Enter.

The neutral plane starts as the Top plane. Faces selected before clicking Draft go to Faces. Each face is tapered about the line where it meets the neutral plane, so the part narrows along the pull direction.

Draft Angle

Angle
The draft angle, in degrees. Must be below 89°. 3 by default.

Neutral Plane

Neutral plane
The plane or planar face about which the faces are drafted. From a planar face the pull direction points into the part; from a plane it points along the plane's normal.
Reverse pull direction
Reverses the pull direction.

Section view of a drafted boss with the neutral plane and the pull direction arrow shown.

Faces to Draft

Faces
The faces to draft: planar faces, or cylindrical faces parallel to the pull direction. Select a row and press Del to remove it.

See Also