Formed Feature¶
Puts a stamped form that Convert to Sheet Metal found, such as a raised pad, a plaque or embossed letters, back on the sheet, and marks it on the flat pattern.
Formed Features have no command of their own. Convert creates one for each form, in a Forms folder right after it in the design tree. To open one's page, double-click it, or right-click it > Edit Feature.
img/sheet-metal/formed-feature-page.png
The Formed Feature page beside a converted door with a raised plaque.
The Form¶
One Formed Feature is one stamp: the faces raised or recessed inside a loop on a wall, front and back. Letters standing on a plaque are part of the plaque's form.
The form's faces are taken from the converted body as they are, and joined to the panel along the loop, so curved and lettered faces stay exact. The page notes the form's size and its height (raised) or depth (recessed).
Parameters¶
- Flat pattern mark
-
How the flat pattern marks the form on its etch layer:
- Outline: the loops the form stands on. The default.
- Center mark: a cross at the middle of the form's bounds.
- None: no mark.
Leaving a Form Flat¶
Suppress the Formed Feature to leave its form flat; the wall runs on over it, as on the blank before stamping. Suppressing the Forms folder leaves them all flat. Suppressing Convert to Sheet Metal suppresses its Formed Features too.
A later feature can change the panel so the form no longer fits, such as a Sheet Cut through it. The form is then left flat, and that feature shows a warning naming the Formed Feature and the reason.
The Flat Pattern¶
The flat pattern is always cut without forms. Each Formed Feature that is not suppressed, and whose form is on the sheet, adds its mark:
- Export Flat: in DXF, outlines are closed polylines and a center mark is two lines, on the shop profile's etch layer. In SVG they are in the ETCH group.
- Flatten: marks are drawn in blue on the flat, with the bend lines.
Marks are not cut, so they don't change the cut length, pierce count or area.
Errors¶
- Form … is not on the converted body any more.
- The imported or modeled body changed, and Convert no longer finds the form. Edit Convert and click OK to write the Forms folder again.